Cleanco Compact 45, Руководство пользователя

Страница: 12 / 84

11
TROUBLESHOOTING GUIDELINES
Loss of Vacuum:

Ensure recovery tank drain valve is closed.

Ensure recovery tank access lids are on properly.

Check recovery tank lid gaskets are in good
condition.

Check stainless steel blower protection filter, clean if
required.

Check vacuum tank lint basket, clean if required.

Check for blockage in cleaning tool or vacuum hose.

Check vacuum hoses for kinks, and good
connections.

Check vacuum hose between blower and recovery
tank.

Check belt tension between blower and pto shaft.

Check belt tension at front of pto shaft.
Loss of Water Pressure

Check fresh water tank for adequate water level, if
connected to direct feed water tap ensure tap is in
the on position.

Inlet water feed line collapsed or clogged.

Inline water filter strainer clogged or damaged.

Air leak on the inlet water line from water source to
high pressure pump.

Check BPR (Balanced Pressure Regulator) for
blockage and proper setting.

Check for lose pump belt.

Check chemical jug, ensure there is enough
chemical.
Water Pulsation

Foreign material in pump valves.

Air leak on the inlet water supply line.

Air leak on chemical metering line.

Inadequate water supply.

Foreign material in BPR (Balanced Pressure
Regulator).
No Hot Water

Check temperature control valve setting, ensure its
turned to hot.

Check engine coolant level, top up if required.

Flush heat exchangers with approved coil cleaner.

Possible air lock in water flow system, make sure
coolant level is at proper level then open pet-cock
valves located on the heat exchangers and bleed air
from heat exchangers, then close pet-cock valves.

If problems persist contact your nearest Cleanco
service center.
No Chemical Feed

Check chemical jug level and top up if necessary.

Check chemical feed hose for leaks or cracks.

Check chemical feed check valve located on the
end of the chemical feed hose in the chemical jug
for blockages.

Check chemical flow-meter for blockages.

Check chemical feed hose from front panel to
chemical injector tee for leaks or cracks.
No Unit Power

Check in-line fuse located at the vehicle battery or
fuse box accessory post.

Check to ensure recovery tank is not full.

Check recovery tank shut-off switch for proper
operation.

Check front pto clutch power and grounding wires.

Check unit power rocker switch for lose wires.

Check Hi-Temp shut-off connections on heat
exchanger and at wiring harness.
Unit Will Not Idle Up

Ensure vehicle is in park.

Ensure Park Brake is engaged.

Check which lights are flashing on E.T.M., all should
be on steady. IF no lights are on check fuse #30 on
GM’s.

If unsuccessful see your local authorized Cleanco
service center.
Unit Shuts Down Unexpectedly

Check recovery tanks level and drain if required.

Check in-line fuse located at the vehicle battery.

Check recovery tank shut-off switch to ensure proper
function.

Check Hi-Temp shut-down on heat exchangers.

Check pto clutch power and grounding wires.

Check Hi-Temp shut off on heat exchangers.