Cleanco Compact 45, Руководство пользователя

Страница: 25 / 84

24
TROUBLE SHOOTING
PROBLEM CAUSE SOLUTION
Recovery tank is full. Drain recovery tank.
PTO will not Main power fuse is blown. Replace fuse.
engage Recovery tank switch is stuck Examine switch replace if necessary.
or defective.
Faulty connection at Hi-Temp
shut-down Check and secure connection at both
sensor and harness
Front or rear belts broken. Replace belts.
Recovery tank is full. Drain recovery tank.
Park brake not engaged Engage park brake.
Engine speed will Fast idle switch is off. Turn switch on.
not increase Throttle Module (ETM) See authorized Cleanco service center
Water supply is turned off Turn the water supply on or up. Check
or the float valve is stuck or for kinks in the water supply hose.
improperly adjusted. Examine the float valve and adjust
or replace.
Water pump inlet supply line is Examine the water inlet filter inside the
plugged or drawing air. water box. Remove accumulated
debris and replace if required. Check
for suction leaks and loose clamps or
fittings. Tighten any loose fittings or
Loss of water clamps. Replace any ruptured hose(s).
pump pressure. Pressure regulator o-rings are Lubricate o-rings, using o-ring lubricant.
dry.
Pressure regulator has worn Check o-rings. If necessary, replace.
With the cleaning o-rings.
tool open, the Pressure regulator is dirty, Clean or repair regulator. Adjust to
water pressure stuck open, or improperly working pressure. Lubricate o-rings,
gauge reads adjusted. using o-ring lubricant.
below the normal Low pump volume. (Measure Examine the check valves, plunger
operating pressure. the amount of water being cups, and cylinder head on the water
returned to the water box from pump. Repair, whenever required
the pressure regulator. It (refer to the water pump service
should fill a gallon container manual).
about every 17 seconds).
Defective water pressure Replace gauge
gauge.
Orifice (spray nozzle) in the Replace nozzle or change nozzle size.
cleaning tool is worn,
defective, or wrong size.
Debris clogging water lines or Clean or replace as needed.
water inlet disconnect.
Belts loose or broken. Re-tension or replace as needed.
Loss of pump prime. Manually prime water pump.