Clavister NetWall 100 Series, Руководство по началу работы

Страница: 49 / 81

Press OK to save the changes. Although changes are remembered by cOS Core, the changed
configuration is not yet activated and won't be activated until cOS Core is told explicitly to use
the changed configuration.
Remember that DHCP should not be enabled when using static IP addresses and also that the IP
address of the
Default Gateway (which is the ISP's router) must be specified. As explained in more
detail later, specifying the Default Gateway also has the additional effect of automatically adding
a route for the gateway in the cOS Core routing table.
At this point, the connection to the Internet is configured but no traffic can flow to or from the
Internet since all traffic needs a minimum of the following two cOS Core configuration objects to
exist before it can flow through the Clavister Next Generation Firewall:
• An IP Policy object in the IP rule set that explicitly allows traffic to flow from a given source
network and source interface to a given destination network and destination interface.
• A route defined in a cOS Core routing table which specifies on which interface cOS Core can
find the traffic's destination IP address.
If multiple matching routes are found, cOS Core uses the route that has the smallest (in other
words, the narrowest) IP range.
An IP policy therefore needs to exist that will allow traffic from clients to the Internet.
Note that with the NetWall 100 Series, the main IP rule set will already contain a number of
predefined entries in the default configuration that will allow clients on the LAN1 interface to
access the Internet via the WAN1 or
WAN2 interfaces. This is discussed in more detail in
Section 4.1, “The NetWall 100 Series Default Configuration” .
This section will discuss how IP rule set entries could be manually created to allow Internet
access for clients on
LAN2 via interface WAN2 .
To add an IP policy, go to Policies > Firewalling > Main IP Rules. The main IP rule set will now
be displayed. Press the Add button and select IP Policy from the menu.
The properties for the new object will appear. In this example, the policy will be called
lan_to_wan . The Service is set to http-all which is suitable for web browsing (it allows HTTP and
HTTPS connections).
Chapter 4: cOS Core Configuration
49