PE 6001
MOVABLE ELECTRO HYDRAULIC LIFT
PE 8001M
BODY REPAIR LIFT TABLE DUAL CYLINDER 3T
35
LOCK :
• Press the LOCK SEC button. Press LOW SB3, the platforms descend.
The safety catch locks onto the safety equipment when the platform height is greater than
500 mm.
Platform is higher than 500 mm.
EMERGENCY STOP :
When the machine has abnormalities when servicing the car, press the «SB0»
(EMERGENCY STOP) button and lock, to cut off the whole operation circuit, so that other
operations cannot work.
ADD OIL AND CHECK THE CONTROL PHASE:
After installing the lifting table and connecting the hydraulic system, electrical system and
gas loop, operate it as follows:
• Open the hydraulic oil tank, add 12L of «20#» hydraulic oil into the oil tank, the hydraulic
oil is provided by the user.
Make sure the hydraulic oil is clean, to avoid any impurity in the oil line, drive the digester
of the oil line and do not operate the solenoid valve.
TROUBLESHOOTING
• Turn on the power button to turn on the motor, by clicking the «UP» button, check if the
motor is running clockwise (looking down), if not turn off the power button, then change
the motor phase.
• Turn on the air power.
When turned on, high voltage exists in the control box, only an authorized person can
operate it in case of electric shock.
EMERGENCY MANUAL OPERATION FOR DESCENT (POWER FAILURE)
When lowering in manual mode, care must be taken to observe the status of the platform
at all times as there is a risk of
There is a vehicle on the platform. If anything abnormal happens, screw the oil loop valve
immediately.
Manual operation process:
• First, lift two safety pawls from the platform and use a thin iron bar to fill it.
• Turn off the «Power» button (avoid sudden power supply).
• Open the small round cover of the control box to find the solenoid valve A for lowering.
• Loosen the manual oil loop pin at the end of the lowering of the solenoid valve core, then
the platform starts to lower.
• Once the machine has been lowered, the manual oil loop pin should be screwed in
Once the machine has been lowered, the manual lowering process is completed.
Picture 7
Содержание PE 8000M
