CLAS PE 8000M, Руководство пользователя

Страница: 32 / 48

PE 6001
MOVABLE ELECTRO HYDRAULIC LIFT
PE 8000M
BODY REPAIR LIFT TABLE MONO CYLINDER WITH
MECHANIC LOCK 3T
32
INSTALLATION AND DEBOTTLENECKING
1 Preparing the ground :
After the dimensional drawing of the lifting table, prepare the ground. In condition, the
preferable ground, concrete thickness
≥
150mm, the leveling of the whole length
≤
5mm.
2 Installation methods: floor bolt installation:
The installation of floor bolts must be after the concrete expiry date. Or the firmness will be
affected.
• Adjust the distance between the left and right platform.
• Use an electric hammer to drill Ø16 pins from the ground bolt hole in the bottom plate to the
ground, the hole to a depth of approximately 120mm, clean the hole and hammer the ground
bolt into the hole.
(Do not install the ground bolt until the levelling adjustment is complete)
Level 3 adjustment :
• Lock the safety catch in the same safety equipment.
• When moving the lifting table platform, adjust the space between two platforms; make sure
that the two platforms are parallel.
To prevent the failure of the safety equipment of the machines, a wooden piece can be
inserted into the middle part of the pivot.
It is forbidden to work under the lifting table when the hydraulic system is not fully equipped
with hydraulic oil and take the action of lifting and lowering operations.
CONNECTING THE LINE :
Connect the electrical line and the oil line according to the «electrical diagram» and the «oil line
connection diagram».
Only after the hydraulic system has been connected can the air loop be connected, so as
not to damage the oil pipes, wires and gas pipes.
In the process of connecting the oil lines, special attention must be paid to
In the process of connecting the oil lines, special attention must be paid to protecting the line
connection to prevent foreign objects from entering the oil loop and damaging the hydraulic
system.