18
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
FITTING SOCKETS AND USING THE AIR RATCHET
1. Select the socket you require and
push it onto the square drive shaft.
• It clicks into place when secure.
2. Place the socket over the nut/bolt.
• Take care that the socket is
firmly engaged.
3. Squeeze the trigger against the
body of the tool to start.
4. Release the trigger to stop the tool.
5. Always ensure the tool has stopped before putting it down.
6. When releasing very tight fastenings initially break loose by hand. Squeeze
the trigger and the air tool will complete the job.
7. If necessary, use penetrating oil to assist in freeing off rusted fasteners.
8. When assembling, start turning fasteners by hand, then set the rotation
forward or reverse. Apply the tool gently and squeeze the trigger to tighten
with power.
9. Final tightening should be completed by hand.
THE BLOW GUN
The blow gun can be used with any of the nozzles listed on page 2.
A 13mm wrench will be required to remove the nozzle already fitted. A hose
(not supplied) will be required to connect to the tyre inflating 2-way chuck
nozzle.
The 0-50psi linear pressure gauge is for indication only and if accuracy is
required, the pressure should be checked with a calibrated pressure gauge.
Содержание X-Pro CAT202
Страница 32: ......
