8
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
19. Provide adequate support to the rear and the sides of the saw table for
long or wide workpieces.
20.
NEVER
leave the saw running unattended. Turn the power off and do not
leave the saw until it comes to a complete stop.
21. Before using the saw on an actual workpiece, let it run for a few moments.
Watch for vibration or wobbling that could indicate poor installation or a
poorly balanced blade.
22.
ALWAYS
hold work firmly against the mitre gauge or rip fence.
23.
NEVER
stand or have any part of your body in line with the path of the saw
blade. keep your hands out of the saw blade path.
24. Feed work into the blade against the direction of rotation only.
25.
NEVER
attempt to free a stalled saw blade without first turning the saw off.
Turn the power switch off immediately to prevent motor damage.
26. Avoid awkward operations and hand positions where a sudden slip could
cause your hand to move into the saw blade.
27. Avoid abrupt, fast feeding. Feed as slowly as possible when cutting hard
workpieces. Do not bend or twist the workpiece while feeding. If you stall or
jam the blade in the workpiece, turn the table saw off immediately. Unplug
the saw, then clear the jam.
28.
NEVER
remove cut-off pieces near the blade or touch the blade guard
while the blade is running.
SAW BLADES
1. Disconnect the saw from the mains supply before changing blades or
carrying out maintenance.
2. The maximum speed of the saw blade must always be equal to or greater
than the no-load speed of the table saw as specified on the rating plate.
3. Only use saw blades recommended by the manufacturer and which are
the exact bore and diameter required for this machine. Do not use any
spacers to make a blade fit onto the spindle. Use only the blades specified
in this manual, which are manufactured in accordance with EN 847-1
standards.
4. Clean the spindle, retaining discs (especially the installing surface) and
retaining bolt before installing the blade. Poor installation may cause
vibration/wobbling or slippage of the blade.
5.
DO NOT
use saw blades which are damaged or deformed.
6. Take care that the selection of the saw blade is suitable for the material to
be cut.
Содержание WOODWORKER 6460015
Страница 32: ......
