23
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
When not in use, store the push stick
in its holder on the side of the saw.
Replace a lost damaged push stick
immediately.
MITRE CUTS
1. Adjust the fence to the required
angle against the mitre gauge
and lock in place with the cam
lever.
2. Set the hinged stop in position
with its thumbscrew.
3. Hold the workpiece against the
fence while pressing against the
hinged stop.
4. Switch on the saw.
5. With the workpiece resting on the mitre table push forward to make the
cut.
IMPORTANT: Always hold the guided part of the workpiece. Never hold the
part which is to be cut off.
6. Push the mitre table forward until the workpiece is cut all the way through.
7. Switch off and
DO NOT
remove the offcut until the blade has stopped.
BEVEL CUTS
Bevel cuts will be made using the
parallel fence.
1. Undo the bevel lock handles (x2)
and set the saw to the desired
angle as displayed on the scale.
2. Tighten the bevel handles at
each side of the machine to lock
the blade at the selected angle.
3. Set the parallel fence.
4. Perform the cut as you would for a ripping cut.
If precision is required, use a protractor between the blade and table.
Содержание WOODWORKER 6460015
Страница 32: ......
