22
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
CUTTING PRACTICE
After every new adjustment, we recommend you to make a trial cut in order
to check the new settings.
RIPPING CUTS & CROSS CUTS
Ripping is when you use the saw to cut along the grain of the wood.
The parallel fence must always be used when making ripping cuts.
1. Press one edge of the workpiece
against the parallel fence.
• The blade guard must always
be lowered over the blade.
2. Set the parallel fence to achieve
the desired width.
3. Switch on the saw.
4. Push the workpiece along the
parallel fence towards the blade.
5. Guide the workpiece with your
hand only as far as the front edge
of the blade guard.
• The Push Handle can also be
used to push the workpiece
during cutting instead of the
push stick.
6. Always push the workpiece
through to the end of the riving
knife using a push stick or push
handle.
7.
DO NOT
remove the offcut piece until the blade has stopped spinning.
8. Support long workpieces with the table extension. A roller stand can be
used to give further support for large items).
CUTTING NARROW WORKPIECES
Always use a push stick when the workpiece is narrow and for holding the
workpiece flat on the table.
Take extra care to keep you thumbs away from the saw blade when feeding
the workpiece past the blade.
Содержание WOODWORKER 6460015
Страница 32: ......
