Clarke Strong-Arm CPL30S, Инструкция по эксплуатации и обслуживанию

Страница: 8 / 22

8
ASSEMBLY & INSTALLATION
Packing piece
Sprocket
Cable channel
Base Frame
Fig. 3
1234567890
1234567890
1234567890
Packing piece
Column resting on
base and packing
piece
FRONT
Fig. 4
Raising the Column with Bottom Plate resting on
Foot of Base Frame and a packing piece
IMPORTANT:
This machine should be assembled by trained personnel only.
NOTE: Unless otherwise stated,the numbers in brackets refer to the parts list item number and number
in corresponding diagram.
1. Base Frame
Position the Base Frame at the desired location,
bearing in mind that the ‘Driving Column’, i.e.
that column carrying the motor and control
panel, must be mounted so that the control panel
faces the shorter foot of the base frame. (see fig.
2), and is at the LEFT HAND REAR of the machine.
Mark out the securing bolt holes, and proceed to
install the foundation bolts.
The base frame should be secured using proper foundation bolts, size - M12 (not supplied), and the
depth of the fixing should not be less than 150mm.
Fig. 2
Long Foot
Driving
Column
Control
Panel
Short Foot
FRONT
LEFT
RIGHT
Installation should be carried out by a qualified person, who
can determine the composition of the surface material and
advise on the correct type of fixing required.
Bolt the base frame down, but do not fully tighten. It may be
necessary to use metal shims, between the floor and frame, in
order to ensure the frame is level. It is not necessary at this stage
to level with absolute accuracy, as this is carried out once the
lift is fully assembled.
2. The Columns
Firstly, fit the Column Dust Covers (Items 35 and 36, Parts List on
page 17) - one to the top of each column, securing them each
with four self tapping screws provided.
Position the Driven Column as shown in Fig. 3, with the bottom
flange of the column resting on the edge of the base and a
packing piece, and the carriage facing inwards.
Raise the column carefully, in the manner shown below. Ensure