Clarke Strong-Arm CPL30S, Инструкция по эксплуатации и обслуживанию

Страница: 15 / 22

15
Oil should be seen moving through the plastic lubricating tube to the drive nut.
If there is no oil present, or if only air bubbles can be seen, remove the side cover and add
oil (Shell Spirex Heavy Duty 85W140 or equivalent is recommended), before re-checking the
pumps’ operation.
3. Remove the base frame Cover Plate to allow access to the chain, and lubricate it with
chain lubricant.
4. Lubricate the upper screw bearings which are accessed from the top of each column.
Apply a few drops of oil to each bearing.
5. Grease the Sliding Carriage Guides. Clean off any excess.
Annually
1. Remove columns’ side panel, pump out the oil from the base of the column. Clean
thoroughly and refill with clean oil (Shell Spirex Heavy Duty 85W140 or equivalent is
recommended).
2. Check for lateral movement of the carriage on its guides. Any movement can be taken up
by adjusting the guide rollers, which are accessed by removing the side panels, and can be
found at each side of the carriage.
Undo the locknuts and screw out the nylon guide rollerss until any wear is taken up. If the
guide rollers are badly worn, contact your Clarke dealer for advice.
3. Check motor Drive Belt tension. The drive belts are located at the top of the drive column.
Belt tension is correct when the belt can be depressed by 12mm (½”) at the middle of its
longest run, using reasonable thumb pressure.
Adjustment is effected by slackening the motor mounting bolts, jacking out the motor to give
the required belt tension, and re-tightening the mounting bolts.
SPECIFICATIONS
CPL30S CPL30T
Motor 230V 50Hz 1Ph 400V 50Hz 3Ph
Power Rating 4HP (3kW) 4HP (3kW)
Fuse Rating 20Amps 20Amps
MAX Capacity 2500kg 2500kg
Please note that the details and specifications contained herein, are correct at the time of going to print. However, CLARKE International
reserve the right to change specifications at any time without prior notice. Always consult the machine’s data plate