Clarke METALWORKER CDP401B, Инструкция по эксплуатации и обслуживанию

Страница: 6 / 32

6
ADDITIONAL SAFETY RULES FOR DRILL PRESSES
1. IMPORTANT: You should not operate this machine unless you are
thoroughly familiar with drilling machines and drilling techniques. If there is
any doubt whatsoever you should consult a qualified person.
2. NEVER operate the machine until it is completely assembled and you
have read and understood this entire manual.
3. ALWAYS use clamps, or a drill vice bolted to the table, to hold the work. It
should never be held in bare hands.
4. ALWAYS shut off the power and remove the drill bit before leaving the
machine,
5. ALWAYS make all adjustments with the power OFF.
6. ALWAYS use the correct drilling speeds for the drill size and the type of
material being drilled (see page 21).
7. NEVER leave the drill unattended whilst it is running. Turn the machine OFF
and do not leave until it has come to a complete stop.
8. ALWAYS remove and store the drill bits when you have finished with the
machine.
9. CAUTION: This machine is designed for use with drill bits and morticing
attachments only. The use of other cutting tools or accessories could be
hazardous.
10. NEVER attempt to drill into a workpiece that does not have a flat surface
unless a suitable support is used.
11. ALWAYS stop the drill before removing workpieces, work supports or swarf
from the table.
12. ALWAYS Make sure you remove the chuck key before turning the machine
on.
13. Adjust the table or depth stop to avoid drilling into the table surface.
14. ALWAYS be sure that the drill bit is securely locked in the chuck.
15. NEVER assemble or set up any work on the table while the drill is running.
16. ALWAYS ensure the table lock is tight before starting the drill.
17. ALWAYS keep hands and fingers away from the drill bit.
WARNING: DUST GENERATED FROM CERTAIN MATERIALS CAN BE
HAZARDOUS TO YOUR HEALTH. ALWAYS OPERATE THE MACHINE IN A
WELL VENTILATED AREA. USE A DUST COLLECTION SYSTEM WHENEVER
POSSIBLE.