Clarke METALWORKER CDP401B, Инструкция по эксплуатации и обслуживанию

Страница: 12 / 32

12
PULLEY COVER KNOB
Locate the knob, with pan head screw and attach to the cover, screwing on
tightly.
FITTING THE DRIVE BELTS
1. Undo the Belt Tension
locking screws (one
either side of the head
- A Fig. 5), and turn the
Belt Tension Lever (B -
Fig. 5), clockwise to
bring the Motor Pulley
closer to the Spindle
Pulley which will allow
the belts to be slipped
on with ease.
2. Lightly grease the Idler
Pulley Pivot shaft and
locate the Idler pulley
assembly in it’s mounting between the motor and spindle pulleys.
3. Consult the chart inside the belt cover (duplicated on page 19), and fit
the belts in the position corresponding to spindle/drill speed required.
4. Turn the Belt Tension Lever ant-clockwise so that tension is applied to the
belts. Tension is correct when the belts deflect by approx. ½” at the centre
of their span when using reasonable thumb pressure. Lock the motor in this
position with the Locking Screw - A.
NOTE:
1. The idler pulley will ‘float’ so that tension is applied equally to both belts.
2. If the belt should slip whilst drilling, adjust the belt tension.
CHECKING THE OPERATION OF THE MICROSWITCH
IMPORTANT:
When closing the cover, check the operation of the Microswitch. It is important that it
operates immediately the cover is pulled open, in order to prevent the machine from
operating........NOT when the cover is opened sufficiently for fingers to be inserted.
If necessary, bend the actuating tab, which is attached to the cover, to ensure this.
Fig 5