Clarke METALWORKER CDP401B, Инструкция по эксплуатации и обслуживанию

Страница: 22 / 32

22
MAINTENANCE
For maximum performance, it is essential that the machine is properly
maintained. Always inspect before use. Any damage should be repaired and
faults rectified.
If the mains lead is damaged it should be replaced immediately.
Please refer to TROUBLESHOOTING on page 23. If you are unable to rectify
any faults, please contact your local dealer or Clarke International Service
Department on 0208 988 7400 for assistance.
AFTER USE
Always remove drill bits, and store in a safe place. The machine requires very
little maintenance other than the following guidelines.
1. Vacuum clean any dust or swarf that accumulates in or on the motor,
drive housing, table and work surface.
2. Lubricate the table bracket and locking handles if they become difficult
to use. Components should be dry, with machined surfaces lightly oiled.
3. Check all cables periodically for security, and that they are in good
condition and not cracked.
IMPORTANT - Disconnect from mains power before cleaning.
MONTHLY (when in constant use)
1. Check tightness of mounting bolts and head and column securing set
screws.
2. Check belt for wear and replace if frayed or otherwise damaged.
3. Blow out any dust/swarf that may have accumulated in the motor fan.
4. Apply a thin coat of wax paste or light oil to the table and column for
lubrication and to help prevent corrosion.
5. Pull the spindle down and lightly oil the spindle sleeve every three months.
• The ball bearings in the spindle are greased and permanently sealed at
the factory and require no further lubrication.
DO NOT attempt to carry out repairs yourself, unless you are fully competent,
all work must be carried out by a qualified technician or the Clarke service
department.