Clarke METALWORKER CDP401B, Инструкция по эксплуатации и обслуживанию

Страница: 15 / 32

15
SETTINGS AND ADJUSTMENTS
TABLE
The table may be raised, lowered or swivelled
about the column, by slackening off the table
support locking handle, (Fig 10), adjusting
accordingly using the table crank, and re-
tightening the locking handle.
If the table assembly moves stiffly when being
swivelled about the column, slacken the upper
collar grub screw (at the rack) to allow the collar
to move very slightly, thereby providing a little
more clearance between rack and collar. Tighten
the grub screw when satisfied.
The table may also be
turned on its axis by
slackening the pinch bolt
at its mounting
spigot,(Fig 2). Note that
the table will only turn
through an arc and will
eventually come into
contact with the
column. Take care not to
cause damage to the
column.
Tilt the table by loosening the Table Tilt Locking
Screw beneath the table, (Item 7, page 26), tilting
to the required position, & re-tightening the
screw.
A bevel scale is provided on the table mounting,
measured in degrees, to assist in setting the
required angle, (Fig 11). For all normal opera-
tions, the table should be set to 0°.
To check to ensure the table is entirely square to the drill, insert a piece of
straight round bar in thechuck, place a square on the table and bring it up to
the round bar. Adjust the table tilt, if necessary, so the table is correctly
aligned.
SPINDLE DEPTH
Located around the spindle feed shaft is a Depth Stop Collar, carrying a
graduated scale (A). The collar is capable of turning about the shaft, and
may be locked in place by a Locking Screw (B). The graduations are imperial
Fig 11
Fig 10
Fig 9