Clarke Metalworker CDP301B, Руководство по эксплуатации и техническому обслуживанию

Страница: 11 / 21

11
Table Tilt Scale
Table Support
Locking Handle
A bevel scale is provided on the table mounting, measured in degrees, to assist in setting the
required angle, (Fig.9). For all normal operations, the table should be set to 0°.
To check to ensure the table is entirely square to the drill, insert a piece of straight round bar
in the chuck, place a square on the table and bring it up to the round bar. Adjust the table
tilt if necessary, so that the table is correctly aligned.
2. Spindle Depth.
(All References are to Fig. 10)
Located around the spindle feed shaft is a Depth Stop Collar, carrying a graduated scale
Fig.10
(A). The collar is capable of turning about the shaft, and may
be locked in place by a Locking Screw (B). The graduations
are imperial (inches) and metric (mm).
To set a drilling depth:
1. With the power OFF, lower the drill bit so that it contacts
the work, and hold in that position.
2. Slacken off the locking screw and turn the collar so that
the measurement for the depth of hole required is in line
with the pointer (C). Lock the collar in this position using
the locking screw.
The drill is now set to drill holes to your pre-determined depth,
from that particular start point.
Fig. 7
SETTINGS and ADJUSTMENTS
1. Table.
The table may be raised, lowered
or swivelled about the column,
by slackening off the table
support locking handle, (Fig.8),
adjusting accordingly using the
table crank, and re-tightening
the locking handle .
If the table assembly moves stiffly
when being swivelled about the
column, slacken the upper collar
grub screw (at the rack) to allow
the collar to move very slightly,
thereby providing a little more
clearance between rack and
collar. Tighten the grub screw
when satisfied.
The table may also be turned on
its axis by slackening the pinch
bolt at its’ mounting spigot,(Fig.1).
Tilt the table by loosening the
Table Tilt Locking Screw beneath
the table, tilting to the required
position, and re-tightening the
screw.