Clarke Metalworker CDP301B, Руководство по эксплуатации и техническому обслуживанию

Страница: 9 / 21

9
A. Column Assembly to Base
ASSEMBLY
CAUTION!
ASSISTANCE MUST BE USED WHEN ASSEMBLING THIS MACHINE.
Fig. 1
Fig. 2
NOTE: Ideally, the base should be firmly bolted to the
floor or workbench, prior to assembly of other
components. The mounting surface must flat, level and
capable of supporting the drills’ weight.
1. With the Base on a flat level surface, bolt on the
Column using the 4, M10 Hex head screws
provided and tighten them fully.
2. Carefully locate the table in its support and nip up
with the table locking handle (Fig.1)
3. Check to ensure the column securing set screws,
at the column support, are tight.
4. Fit the crank to the spigot on the crank assembly.
B. Head to Column
NOTE : It may be necessary to unscrew the Head Lock Set
Screws (A Fig. 2) slightly to ensure they do not protrude
internally as this would prevent the head from sliding fully
into position.
1. With assistance, raise the head and locate it on
top of the Column.
2. Align the head with the base and firmly secure
with the set screws (A), using the wrench provided
3. Locate the three feed handles (Fig. 3) and screw
them firmly into the hub of the spindle feed shaft.
C. Chuck Guard Assembly
.
NOTE: This operation should be carried out before the
chuck is installed.
Slide the Chuck Guard over the Quill Shaft, turn it so that
the pinch bolt faces the front, then nip up the pinch bolt
to temporarily secure it in this position, as shown in fig. 4.
IMPORTANT: Ensure the Quill Shaft/Spindle is at the
top of its travel.
D. Pulley Cover Knob.
Locate the knob, with pan head screw and attach to the
cover, screwing on tightly.
Fig. 3