8
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
BEFORE USE
CHECK OIL
1. Remove the cover from the
pressure washer by removing the
securing screw from each side of
the cover then lifting the cover
off.
2. Turn the oil filler cap anticlockwise
and remove it from the pump,
wipe the integral dipstick with a
clean cloth.
3. Insert the oil filler cap back into
place and then remove it again.
4. If the oil reads low on the dipstick,
add oil to the oil reservoir (Max
0.463L).
• Do not overfill the oil reservoir.
• We recommend the use of
SAE30W oil.
• Do not mix grades of oil as this may effect the pressure washers
performance.
5. Replace the oil filler cap.
6. Replace the cover and tighten the securing screws
NOTE:
Running the pump with insufficient oil will cause damage.
WARNING: TO CARRY OUT THIS CHECK, PLACE THE PRESSURE WASHER ON
LEVEL GROUND WITH THE PRESSURE WASHER SWITCHED OFF.
WARNING: TAKE CARE NOT TO TOUCH ANY HOT PARTS WHEN CHECKING
THE OIL LEVEL.
HLS160 3 Phase hot wash.fm Page 8 Wednesday, September 28, 2011 12:28 PM
Содержание HLS160
Страница 24: ......
