25
ADJUSTING 90 AND 45 DEGREE POSITIVE STOPS
Fig.35
Fig.36
WARNING!
ENSURE THE PLUG IS DISCONNECTED FROM THE POWER SUPPLY BEFORE PROCEEDING
ADJUSTING THE POSITIVE STOPS
1.
Raise the blade to maximum height.
2.
Turn machine so that it rests on the table top’s
side edge and is supported in some way,
ensuring it is stable.
3.
Remove the bottom grill by removing the 6
screws shown.
4.
Adjust the Positive stops, indicated in Fig. 35, as
required, checking the blade angle using a set
square and protractor as necessary.
5.
When completely satisfied, ensure the stops are
properly locked, then replace the bottom grille.
RENEWING MOTOR BRUSHES
1.
Turn machine so that it rests on the table top’s side
edge and is supported in some way, ensuring it is
stable.
2.
Remove bottom grille.
3.
Unscrew and remove the Brush Caps, (one either side
of the motor housing), then withdraw the brush with
springs attached.
4.
Carefully insert replacement brushes and replace the
screw on caps.
Fig.34
NOTE: Always replace both brushes at the same time.
