14
E. RIP FENCE
The rip fence has the following parts:
1.
The handle assembly ‘A’
2.
The fence ‘B’
3.
Two fixings, each comprising a coach bolt and
securing knobs ‘C’.
1.
Slide the handle assembly (A) into the slot in the
front rail, and push the handle down to lock the rip
fence to the table.
2.
Pull the slide bar out slightly and slide the fence (B)
behind the slide bar as shown.
3.
Tighten the securing knobs (C) to lock the fence to
the handle assembly.
Note: The rip Fence has two slots, allowing the fence
to be attached in the ‘high’ or ‘low’ position
Fig.8
Fig.19
Fig.9
F.
CONNECT THE VACUUM HOSE
1.
Attach the hose as shown in the diagram in Fig.9
2.
Connect a vacuum cleaner to the dust outlet port
on the rear of the table saw.
