11
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
HEAD TO COLUMN
NOTE:
It
may be necessary to unscrew the
set-screws (shown in fig.4) to
ensure they do not protrude internally and foul the column, as this
would prevent the head from sliding fully into position.
1. With the help of an assistant, lift up
the head assembly and locate it
on the column, ensuring it slides
fully home.
2. Align the head assembly with the
machine base and tighten the
head locking set screws shown in
Fig 5 using the hex key supplied.
3. Take the three feed handles and
screw them firmly into the hub of
the feed shaft as shown in Fig.6.
CHUCK GUARD ASSEMBLY
This task should be carried out before
the chuck is installed.
1. Slide the chuck guard over the
quill shaft and nip up the pinch
bolt, temporarily, with the pinch
bolt facing the front (see fig 7).
• This will make fitting the chuck
easier. Ensure the quill shaft/
drive spindle is at the top of it’s
travel.
