17
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
8. When completely satisfied that
the setup is correct, lower the
chuck guard into position and
switch the machine ON.
• Switch on by pushing the ‘I’
button.
• To switch OFF, push the ‘O’
button, see Fig 16.
9. During use, the emergency stop
button will drop down over the
other buttons. To stop the machine instantly, just strike the red button. To re-
start, unclip and lift the hinged stop button/cover to access the regular
start/stop buttons.
NOTE:
As a safety feature, the ON/OFF switch is a ‘No Volt Release’ type.
Therefore, if the power is interrupted whilst the machine is
switched ON, it will not automatically start when power is restored.
10. Slowly turn the feed handles to bring the drill bit down towards the table
and into your workpiece. Ease the drill bit back up to clear swarf away as
required. After drilling, release the feed handles slowly to return the
machine to its starting position.
