16
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
MAINTENANCE
For maximum performance, it is essential that the machine is properly
maintained. Always inspect it before use. Any damage should be repaired,
and faults rectified. Always unplug from the power supply before carrying out
any adjustment, servicing or maintenance.
Please refer to the troubleshooting chart on page 17. If you are unable to
rectify any faults, please contact your local dealer or Clarke International
Service department for assistance.
MONTHLY (IF IN CONSTANT USE)
1. Check tightness of mounting bolts, and the head and column securing set
screws.
2. Check the drive belt for wear, and replace if frayed or damaged.
3. Blow out with compressed air, or vacuum clean out, any dust that may
have accumulated in the motor fan vents.
4. Apply a thin coat of wax paste or light oil to the table and column, for
lubrication, and to help prevent corrosion.
If the mains lead is damaged in any way it should be replaced immediately.
LUBRICATION
All bearings are packed with grease
at the factory and require no further
lubrication.
Occasionally, lubricate the quill shaft
assembly with light oil if required.
AFTER USE
1. Remove all swarf from the
machine and thoroughly clean all
surfaces.
2. Components should be kept dry, with machined surfaces lightly oiled.
3. Always remove drill bits and store in a safe place.
