10
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
3. Add the two adjustment locknuts
nuts to the depth stop and slide
the pointer to the tip of the stop
rod as shown in Fig 6.
• The pointer may be zeroed by
sliding it up or down on its
mounting.
INSTALLING THE CHUCK
1. With the chuck guard lifted clear
of the spindle, slide the work table
up the column to within 6" of the
spindle.
2. Fully open the jaws of the chuck
using the chuck key supplied.
3. Put a piece of scrap wood on the
table to protect the chuck nose
as shown in Fig 7.
4. Ensuring all parts are thoroughly
clean, dry, and burr free, place the chuck over the end of the spindle and
pull the spindle down using the feed handles. Press the chuck jaws hard
against the piece of scrap wood until the chuck is forced home. Discard
the scrap wood.
5. When the chuck is installed, turn the chuck guard around so that the shield
is facing the front and tighten the pinch bolt to align the guard.
TENSIONING THE DRIVE BELT
The drive belt is pre-installed as in Fig
8, but should it require tensioning,
proceed as follows:
1. Open the cover to access the
belt.
• Tension is correct when the belt
deflects by approx. ½” at its
centre, when using reasonable
thumb pressure.
2. To adjust the belt, undo the belt
tension locking knob shown in Fig 9, to relieve the tension on the belt.
