9
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
HEAD TO COLUMN
1. Lift the head assembly and locate
it on top of the column, ensuring it
slides home fully.
NOTE:
It may be necessary to
unscrew both the head
locking set screws slightly, to
ensure they do not protrude
internally, as this would
prevent the head from
sliding fully into position.
2. Align the head with the base, and
firmly secure it to the column with
the set screws as shown in Fig 2.
Tighten with the hex key supplied.
3. Screw the three feed handles
firmly into the hub as shown in Fig
3.
CHUCK GUARD ASSEMBLY
This must be fitted before the chuck is
installed.
1. Slide the chuck guard assembly
over the drive spindle and tighten
the pinch bolt at the rear of the
assembly shown in Fig 4.
ASSEMBLING THE DEPTH STOP
1. Slide the end of the threaded rod
through the bracket on the side of
the head, then through a washer
and through the hole in the top of
the chuck guard support as
shown in Fig 5.
2. Secure with the nut from beneath,
locking the depth stop to the
chuck guard and the spindle
assembly. (In use, as the spindle is
moved downwards, the depth
stop will move by the same amount).
