Clarke 6500685, Инструкция по эксплуатации и обслуживанию

Страница: 10 / 32

SPINDLE SPEEDS
A chart showing spindle speeds and recommended turning speeds is mounted on the Head cowl
and for convenience, is duplicated as follows:
CAUTION : MAKE SURE THE POWER CORD IS
REMOVED FROM THE OUTLET BEFORE
ATTEMPTING TO CHANGE THE BELT POSITION.
Changing speeds
1. Undo the two screws securing the Pulley
Access Panel.
2. Slacken the four Motor securing bolts -
2 are arrowed in Fig. 9.
3. Pull up the lower - motor pulley to relieve
belt tension.
4. Move belt to appropriate pulley’s.
5. Push down on the lower pulley to tension
the belt. It should be firm - 1/2” total
movement at the middle of the run.
6. Retighten Motor securing bolts and replace
Pulley Access Cover.
10
SPINDLE SPEEDS
RECOMMENDED GENERAL SPEEDS
SPINDLE TURNING
SQUARE LENGTH ROUGHING FINISHING
1” (25mm) 12” (305mm) 1750 2510
2” (50mm) 16” (406mm) 1250 2510
3” (75mm) 20” (508mm) 850 2510
4” (100mm) 20” (508mm) 850 2510
DIAMETER THICKNESS ROUGHING FINISHING
9” (228mm) 4” (100mm)Max. 850 2510
8” (205mm) 4” (100mm)Max. 1250 2510
6” (150mm) 4” (100mm)Max. 1750 2510
FACE PLATE TURNING
Fig.9 shows the belt positioned on the second
step from the outside edge of the pulley. This
produces a spindle speed of 1250 RPM. (Refer
to the chart above).
If you wish to run at a higher speed, say 2510
RPM, you must shift the belt inwards, 2 steps.
Fig.9