29
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
6. Adjust set screw with a 4mm hex wrench, then tighten hex bolt loosened in
step 4.
NOTE:
Tightening the set screw will move the blade closer to the shoulder
of the wheel.
NOTE:
Loosening the set screw will move the blade away from the
shoulder.
7. Re-tension the blade as set out on page 27.
8. Reconnect the machine to the power source and turn the bandsaw on.
NOTE:
If the blade tracks along the shoulder of the wheel (without
rubbing), the blade is tracking properly and this adjustment is
complete.
NOTE:
If the blade walks away from the shoulder of the wheel or hits the
shoulder, repeat sets 4 - 7 until the blade tracks correctly.
9. Turn off the bandsaw.
10. Replace the blade guard and wheel access cover.
SQUARING THE BLADE
It is always a good idea during the life of your saw to check and adjust this
setting. This adjustment will improve your cutting results and extend the life of
the blade.
TO SQUARE THE BLADE TO THE BED OF THE TABLE.
1. Disconnect the machine from the power source.
2. Lower the head of the bandsaw until it contacts the horizontal stop.
3. Place a square on the table bed
and against the edge of the
blade as shown, and check the
different points along the length
of the table between the blade
guides.
4. Loosen the cap screw shown, and
rotate the blade guide until the
blade is vertical to the bed.
NOTE:
Both the blade guides can
be adjusted to achieve the
results you want.
5. Tighten the cap screw.
Содержание 6460123
Страница 44: ......
