Clarke 6460120, Инструкция по эксплуатации и обслуживанию

Страница: 13 / 23

When the Frame reaches
the bottom of its travel, a
bracket, attached to the
Frame,
(‘A’ Fig.13),
presses
down on the OFF switch,
(‘B’ Fig.13),
switching Off the
machine. ALWAYS ensure
the bracket is positioned so
that this will operate
correctly.
Adjust the bracket in conjunction with the Frame Stop, shown in Fig. 13A. Adjust
the Stop so that the OFF switch is activated, without the full weight of the Frame
being supported by the switch.
A. ‘Running In’ the Blade
To gain the maximum working life from your blade it is also essential for a new
blade to be ‘RUN IN’ for a short period of time. This is done by applying a lighter
cutting pressure on the first few cuts made by the blade. As a guide the ‘Running
In’ cutting pressure should be half the normal cutting pressure. The cut will therefore
take longer to complete.
B. Converting for Vertical Cutting
With the head in the vertical position, the bandsaw may be used for notching,
slitting and cutting curves, by hand as shown in Fig. 14. This is achieved by
attaching a work table to the Fixed Blade Guide Block, shown in Fig. 14A, using
Fig. 14
two countersunk screws
provided, in the holes
shown arrowed at ‘A’.
Fig. 15
Fig. 15 shows the
table installed, with
the two securing
screws arrowed.
Fig. 13 Fig. 13A
Fig. 14A
13