Clarke 6460120, Инструкция по эксплуатации и обслуживанию

Страница: 16 / 23

If the blade tends to run off the rim of the pulley wheel, turn the Hex. socket head
screw, shown at ‘B’ fig.19, using a 4.5mm wrench, CLOCKWISE, by one quarter
turn only, then retighten the two screws shown at ‘A’.
Turn the blade by hand, ensuring you are wearing a suitable pair of industrial
gloves, checking to ensure the blade runs neatly, just off the lip on the back edge
of the pulley wheel. If necessary, slacken off the two screws ‘A’ and repeat the
process.
If the blade tends to climb the lip on the back edge of the pulley wheel, the screw
at ‘B’ should be turned ANTICLOCKWISE, following the same procedure.
As a final check, ensure the blade tension is correctly set, replace the blade guard,
then plug in to the mains supply and switch ON. If run-off is noted, repeat the
process until completely satisfied.
D. Cleaning
It is recommended that the Bandsaw is kept clean and free of filings, swarf etc.,
by cleaning with a brush , paying particular attention to the Blade Guides. Keeping
the vice free from residue will ensure that the work sits square to the blade, giving
a more accurate cut.
Always clean and dry the machine at the end of a days work, particularly when
coolant has been used.
E. Lubrication
To ensure proper running of your machine, the following Lubrication Schedule
should be followed, using SAE30 oil.
1.
Weekly,
6-8 drops on the Driven Pulley Bearing (Lower Pulley). The Pulley Cover
must be removed to accomplish this task.
2.
As required
- Vice Screw ....ensure it is clean and free from foreign material.
3.
Annually
- The oil requires changing in the Gearbox Annually, or more often if
the oil becomes contaminated, or an oil leak occurs.
To change the oil, remove the Hex. socket head screw plug, located on the
right hand side of the gearbox, and allow the oil to drain into a container.
Replace the plug and fill to the bottom of the oil filler hole with gear oil.
16