17
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
3. If another collet is to be used,
undo the screw cap completely
and pull out the collet from the
collet seat. Replace it with the
new collet and screw the cap
loosely back on.
FITTING THE GRINDING STONE
IMPORTANT: Never use chipped or
cracked grindstones.
1. Slip the shank of the chosen stone
into the collet and tighten the
screw cap finger tight.
2. Place the smaller of the two
wrenches over the collet seat to
stop the tool from rotating.
3. Use the larger wrench to fully
tighten the collet and grip the
stone in position as shown.
OPERATING THE DIE GRINDER
1. Slide the throttle locking lever
forward while squeezing the
trigger against the body of the
tool.
2. Allow the tool to reach full working
speed before presenting the
grinding stone to the workpiece.
Do not use excess pressure on the
grinding stone as this will shorten
its life.
3. Release the trigger to stop the grinder.
• The tool will continue to rotate for a short time after the trigger has
been released.
4. Always ensure the grinder has stopped before putting it down.
DISCONNECTING THE AIR SUPPLY
1. Do not disconnect the hose until the supply is isolated at a shut-off valve.
2. Once the pressure has been isolated, disconnect the air supply hose. Shut
down the compressor at the end of the session.
Содержание 3110876
Страница 32: ......
