13
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
ADJUSTING THE FORCE
Chisel force may be adjusted by
turning the regulator knob, located at
the base of the handle.
• Turn anticlockwise to increase
force.
• Turn clockwise to reduce the
force.
USING THE CHIPPING HAMMER
1. Hold the tool firmly, then bring the
tool towards the work at an angle
of approximately 60-70 degrees.
2. Squeeze the trigger with the chisel
in light contact with the work.
3. Move slowly across the work
surface. To remove scale, rust or
other contaminants, only a light
force should be required.
4. Release the trigger to stop
operation whilst maintaining contact with the work.
5. The tool may operate briefly after the trigger is released.
NOTE:
The retaining spring has a life expectancy, depending upon the
intensity of usage. It is recommended that you procure a spare
spring for use in the event of failure occurring during the course of
a particular job.
DISCONNECTING THE AIR SUPPLY
1. Do not disconnect the air hose until the supply is isolated at a shut-off
valve.
2. Once the pressure has been isolated, disconnect the air supply hose.
3. Shut down the compressor at the end of the work session.
Содержание 3110876
Страница 32: ......
