15
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
2. Open sufficiently to take the drill bit.
3. Place the drill bit in the jaws of the chuck as far as it will go.
4. Close the chuck jaws and tighten to grip the drill bit by turning the chuck
key as shown.
5. Make sure that the chuck jaws are fully closed and that the drill bit is firmly
held.
DIRECTION CONTROL SWITCH
The direction control switch should be used as follows.
1. For normal drilling the drill must be
operated in the forward (F)
direction.
2. If the drill bit jams whilst drilling,
release the trigger switch.
3. When the drill has come to a
complete stop, move the direction
control switch to the reverse (R)
position.
USING THE REVERSIBLE DRILL
1. Squeeze the trigger switch to start the air drill.
2. Wait until the air drill is running at its maximum speed before applying it
carefully to the workpiece.
3. Release the trigger switch to stop the air drill.
DISCONNECTING THE AIR SUPPLY
1. Do not disconnect the hose until the supply is isolated at a shut-off valve.
2. Once the pressure has been isolated, disconnect the air supply hose.
3. Shut down the compressor at the end of the session.
WARNING: WAIT UNTIL THE CHUCK HAS STOPPED ROTATING BEFORE
OPERATING THE DIRECTION CONTROL SWITCH.
WARNING: MAKE SURE THAT THE CHUCK KEY HAS BEEN REMOVED
BEFORE USING THE DRILL.
Содержание 3110876
Страница 32: ......
