62
VZ509A
English
INSTAL
LATIO
N
MAN
UAL
6. REMOVING THE MAIN UNIT
1. When the rear of the main unit has been
secured with the method shown in Figure 6
unfasten the special screw.
2. Remove the outer escutcheon.
3. Insert the hook plate between the spring and
the universal mounting bracket, fit tab
B
of
the spring into hole
A
of the hook plate, then
pull the main unit out by the hook plate. (Insert
both the right and left edges of the hook
plate.) (Figure 9)
Note:
Keep the hook plate. You cannot remove the main
unit without disengaging the hook plate.
7. CAUTIONS ON WIRING
• Be sure to turn the power off before wiring.
Be particularly careful where you route the
wires.
• Keep them well away from the engine, and
exhaust pipe, etc. Heat may damage the wires.
• If the fuse should blow, check to see if the
wiring is correct.
If a fuse is blown, replace it with a new one of
the same amperage rating as the original (15A
FUSE).
• To replace the fuse, remove the old fuse of the
power supply cord and insert the new one.
(Figure 10)
Note:
•
There are various types of fuse holder. Do not let
the battery side touch other metal parts.
CAUTION
caution
After the connection, fix the cord by a clamp
or insulation tape for protection.
A
B
Universal mounting bracket
Figure 9
MainUnit
Instrument panel
Spring
2-Hook plate
Outer escutcheon
Fuse (15A FUSE)
Figure 10
Fuse holder
