uTouch User Manual
v1.6
7
4
Mounting the unit
The uTouch unit is consisted of two parts – back plate and the main unit.
First you need to mount the back plate.
Before actually mounting the back plate, put it on the surface and position it so that the top
edge of the plate is at least 150 cm (5 ft) from the floor. Then mark the 4 holes for the screws.
The M2 screws and anchors are included in the package with the unit itself. If you lose them,
you can use M1,5 to M2,5 screws with bugle heads, and with adequate anchors if needed.
After mounting the back plate firmly on the mounting surface, connect all the cables needed
for installation to the respective terminals. Because of limited space between the unit and the
surface, make a bigger hole in the surface to house the needed cables in needed length.
After making all the connections, position the unit on the back plate and slide it up into place.
If everything is properly done, the unit will slide approximately 1 cm (1/2”).
The last move is to fasten the unit to the back plate from below, by using two supplied
screws.
