Access codes
There are two User codes used in the system,
both are 4 digit and can be set to any number
from 0000 to 9999, signified by:
The user 1 and 2 codes have the same operation
for testing, Setting and Unsetting, but user 1
code which is usually considered to be the
Managers code has the authority to add, change
or delete the user 2 code.
ÿ
User 1 code 0123 factory set
ÿ
User 2 code not programmed.
How to operate Personal Attack
Personal Attack buttons on the keypad are used
to activate the alarm, irrespective of whether the
system is armed or not.
Press Simultaneously:
How to unset system in alarm
Enter your code. Entering the code will turn the
alarm off and the cause of the alarm will be
displayed. After investigation press Reset to
clear the indication.
Note:
If the alarm indication does not
clear, then the system may need to be
reset by the installation engineer, contact
your installer for further information.
Programs 1, 2 and 3
The panel uses 3 Part Set routines known as
Programs. In each Program the exit mode can be
changed and the zone may be set up to have a
different function.
The examples below show how 3 typical
Programs could be used in a house.
Program 1
To arm all of the zones and become
Set as the user leaves the property and closes the
final door.
Program 2
To protect the perimeter of the
property in the evening and become Set after say
20 seconds.
Program 3
To protect the downstairs areas of
the house at night and become Set silently.
The above are purely examples. The installer has
the ability at the programming stage to configure
all the circuits to the customer’s exact
requirements.
2
4188 693 issue 1 8/01
Operating instructions
Citadel XR1 G3 Intruder system
Access
codes
Contents
Unset system indications
1
Set System indication
1
Access codes
2
How to operate Personal Attack - - - - - - 2
How to unset system in alarm - - - - - - - - 2
Programs 1, 2 and 3
2
How to set the system (on program 1) - - - - 3
Push to Set Switch
3
Keyswitch Set
3
Faults during setting
3
How to unset the system (turn off) - - - - - 3
How to set program1,2 or 3 - - - - - - - - - 3
How to Quick set - - - - - - - - - - - - - - 4
How to Omit zone(s) on setting system - - - 4
Fire Alarm
4
How to set Chime Zones - - - - - - - - - - 4
Operator’s Program mode
5
To exit operation at any time
5
How to enter Operator’s program mode - - 5
How to view the events log - - - - - - - - - 5
How to create/omit User 2 code - - - - - - - 6
How to change current user code - - - - - - 6
How to carry out Alarm and Walk tests- - - 7
Servicing organisation details
7
Quick Reference
8
4
9
Reset
n
n
n
n
Bell
Alarm
FIRST ZONE IN ALARM
OTHER ZONES IN ALARM
Investigate the Alarm
Strobe Off
ALL ZONE
Day
n
n
n
n
www.ukpanels.com
