How to set the system (on
program 1)
The green Day indicator should be showing.
Enter your code
number and check
that the system is
clear (none of the
zone indicators
are showing). The
sounder will now
produce an exit
beep tone and you
should leave by
the approved
route. The system
will Set as the
beep tone stops.
Push to Set Switch
In some systems a Push to Set switch may be
fitted outside the premises near to the main exit
door. This should be used to complete the setting
procedure once the building has been vacated.
As the switch is operated, the exit beep tone will
stop and a chime tone will be produced to
acknowledge setting.
Keyswitch Set
Your system may have been fitted with a remote
keyswitch. This can be used as an alternative to
arming the system with a code and will set
Program 1.
Where a keyswitch is used it may be necessary
on occasions to allow it to catch up with the
system. For example if the alarm was set with a
code, to Unset with the keyswitch, it would have
to be momentarily turned to Set then returned to
Unset.
Faults during setting
If the system is not clear when you try to Set it,
the sounder will produce an open zone tone and
the fault will be displayed. Either re enter your
code to turn off and investigate or omit the faulty
zone(s) from the system.
How to unset the system (turn
off)
On entering the premises an entry beep tone
come on. Enter your code, the green Day
indicator is lit. The system is unset and
disarmed.
How to set program 1,2 or 3
The green Day indicator should be showing.
Enter your code
number and the
exit beep tone
will start. Press
the Prog key and
the exit tone will
stop. Press 1, 2
or 3 for the
required
program, the
sounder will
beep to
acknowledge the
program number. The exit beep tone will start
and you should leave by the approved route. The
system will Set as the beep tone stops.
It is important that you follow the correct
procedure when setting the system. After leaving
the protected area it is absolutely essential that
you wait until the exit tone stops, before
assuming the system has set.
4188 693 issue 1 8/01
3
Citadel XR1 G3 intruder system
Operating instructions
How
to
set
the
system
(on
program
1)
n
n
n
Day
Day
10seconds
insistent beeps
Exit beep
n
n
n
n
n
Day
Day
Acknowledge
Entry beep
Prog
n
n
n
n
Day
3
2
1
Or
Day
Exit beep
Exit beep
10 seconds
insistent beeps
ZONE 1-3
Exit beep
www.ukpanels.com
