Cisco UCS C250, Инструкция по установке и обслуживанию

Страница: 71 / 92

3-35
Cisco UCS C250 Server Installation and Service Guide
OL-20888-02
Chapter 3 Maintaining the Server
Installing or Replacing Components
Figure 3-18 Removing and Replacing a PCIe Card
Special Considerations for the Cisco UCS P81E Virtual Interface Card (N2XX-ACPCI01)
The Cisco UCS P81E Virtual Interface Card is a standard-profile, half-length, dual-port 10 Gb PCIe card
with SFP+. See the following special considerations and prerequisites.
•
This card is supported in server Generations M1 and M2.
•
This server supports installation of up to two of these cards.
•
These cards are supported only in PCIe slots D and E of this server.
Note
This card must be installed in PCIe slot D to use the Cisco Card NIC mode (see Figure 3-17 on
page 3-33 ). See also NIC Modes and NIC Redundancy Settings, page 2-12 .
•
This card requires that the server has CIMC firmware version 1.2(1) or later installed. There is a
heartbeat LED on the top and bottom of the card that indicates when firmware is active.
•
To use this card for UCS integration (UCSM mode) with Cisco UCS Manager 2.0(2xx) or later, the
minimum card-firmware and uboot image level is 2.0(2g).
•
To use this card for UCS integration (UCSM mode) with Cisco UCS Manager 1.4 or 2.0(1), the
minimum card-firmware and uboot image level is 1.4(1i).
•
To connect this card to an upstream Cisco Nexus fabric interconnect (switch), the minimum NXOS
version on the fabric interconnect must be 5.0 or later.
195987