Cisco UCS C250, Инструкция по установке и обслуживанию

Страница: 66 / 92

3-30
Cisco UCS C250 Server Installation and Service Guide
OL-20888-02
Chapter 3 Maintaining the Server
Installing or Replacing Components
Installing a Motherboard CMOS Battery
The qualified and supported part numbers for this component are subject to change over time. For the most
up-to-date list of replaceable components, see the following URL and then scroll to
Technical Specifications :
http://www.cisco.com/en/US/products/ps10493/products_data_sheets_list.html
Warning
There is danger of explosion if the battery is replaced incorrectly. Replace the battery only with the
same or equivalent type recommended by the manufacturer. Dispose of used batteries according to
the manufacturer’s instructions.
Statement 1015
To install or replace a motherboard CMOS battery, follow these steps:
Step 1
Remove a motherboard CMOS battery:
a. Power off the server as described in the “Shutting Down and Powering Off the Server” section on
page 3-9 .
b.
Disconnect all power cords from the power supplies.
c. Slide the server out the front of the rack far enough so that you can remove the top cover. You might
have to detach cables from the rear panel to provide clearance.
Caution
If you cannot safely view and access the component, remove the server from the rack.
d.
Remove the top cover as described in the “Removing and Replacing the Server Top Cover” section
on page 3-10 .
e. Press the battery socket retaining clip toward the chassis wall (see Figure 3-15 ).
f.
Lift the battery from the socket. Use pliers to grasp the battery if there is not enough clearance for
your fingers.
Step 2 Install a motherboard CMOS battery:
a.
Press the battery socket retaining clip toward the chassis wall.
b. Insert the new battery into the socket with the battery’s flat side and positive marking (+) toward the
outer chassis wall. Ensure that the retaining clip clicks over the top of the battery.
Note The flat, positive side of the battery marked with “+” must face the outer chassis wall.
c. Replace the top cover.
d.
Replace the server in the rack, replace power cords and any other cables, and then power on the
server by pressing the
Power button.