Cisco UCS C250, Инструкция по установке и обслуживанию

Страница: 53 / 92

3-17
Cisco UCS C250 Server Installation and Service Guide
OL-20888-02
Chapter 3 Maintaining the Server
Installing or Replacing Components
Installing a DVD Drive
The qualified and supported part numbers for this component are subject to change over time. For the most
up-to-date list of replaceable components, see the following URL and then scroll to
Technical Specifications :
http://www.cisco.com/en/US/products/ps10493/products_data_sheets_list.html
Warning
Class 1 laser product.
Statement 1008
To replace a DVD drive, follow these steps:
Step 1 Remove a DVD drive:
a.
Power off the server as described in the “Shutting Down and Powering Off the Server” section on
page 3-9 .
b. Disconnect all power cords from the power supplies.
c.
Slide the server out the front of the rack far enough so that you can remove the top cover. You might
have to detach cables from the rear panel to provide clearance.
Caution If you cannot safely view and access the component, remove the server from the rack.
d. Remove the top cover as described in the “Removing and Replacing the Server Top Cover” section
on page 3-10 .
e.
Remove the cable from the connector on the rear of the DVD drive (see Figure 3-11 ).
f. Remove the one screw that secures the DVD drive to the chassis.
g.
Push the DVD drive out of the front chassis opening.
Step 2 Replace a DVD drive:
a.
Align the new DVD drive with the front panel opening and push it into the chassis until the front
plate is even with the chassis front.
b. Replace the one screw that secures the DVD drive to the chassis.
c.
Replace the cable to the connector on the rear of the DVD drive.
d. Replace the top cover.
e.
Replace the server in the rack, replace power cords and any other cables, then power on the server
by pressing the
Power button.