Installing the UC 320W and Phones
Connecting a Phone to the Network
Unified Communications UC 320W Administration Guide
32
1
Connecting a Phone to the Network
Connecting a Phone with an Ethernet Cable
STEP 1
Insert one end of the Ethernet cable into the network port on the phone body
marked “SW.”
STEP 2
Insert the other end of the Ethernet cable into a LAN port of the UC 320W or into a
LAN port on an Ethernet switch.
NOTE
On all models excepts Cisco SPA 301, you can connect a PC to the phone’s second
Ethernet port (see
This port can be used when the
phone is connected the LAN with an Ethernet cable, but not when the phone is
operating wirelessly.
Connecting a Cisco SPA 525 Model Phone to the UC 320W
Wireless Voice Network
If you enable the wireless voice network in the UC 320W configuration utility,
Cisco SPA 525 models can be used wirelessly. The wireless profile will be added
to the phone during the initial configuration.
IMPORTANT:
For initial configuration of the phone, use an Ethernet cable. After
entering the settings, including the wireless network settings, apply the
configuration in the UC 320W configuration utility. Wait for all devices to reboot
and reinitialize. At that point, you can begin this procedure.
Follow this procedure to verify that your phone is connected to the UC 320W
wireless network. This procedure also explains how to connect to the network if
the wireless connection is not made automatically.
STEP 1
If an Ethernet cable is connected to the phone, remove it and wait for the phone to
reboot. If an Ethernet connection is present on the phone, it is used instead of the
Wi-Fi connection.
STEP 2
Press the Setup button on your phone.
STEP 3
Scroll to
Network Configuration
and press
Select
.
