Cisco RV340 Series, Руководство администратора

Страница: 55 / 110

To configure WAN Queuing, follow these steps:
Step 1 Click QoS > WAN Queuing .
Step 2 Above the WAN Queuing Table, select the desired Queuing Engine ( Priority, Rate-control, or Low-latency ).
Step 3 In the WAN Queuing Table, click Add and enter a name for the policy and provide a description.
Step 4 If Priority Queuing was selected, in the Queuing Priority Table, select the Traffic Class for each queue from the drop-down
list.
Step 5 If Rate Control Queuing was selected, in the Queuing Rate-Control Table, select the Traffic Class and enter the Minimum
and Maximum Rate for each queue.
Step 6 If Low-latency Queuing was selected, in the Queuing Low-Latency Table, select the Traffic Class and configure the
bandwidth share value for each queue.
Step 7 Click Apply .
WAN Policing
In WAN Policing, the rate-control mode supports eight queues. Each queue can be configured with a maximum
rate.
To configure the WAN Policing page, follow these steps:
Step 1 Click QoS > WAN Policing .
Step 2
Check Enable policing of traffic on WAN interfaces .
Step 3 In the Policy Class Table, configure the following for each queue:
Select Unspecified or Default. Traffic class
Enter the queue
’
s maximum rate of bandwidth in percentages to limit the incoming
traffic from WAN to LAN.
Maximum Rate
Step 4 Click
Apply
.
WAN Bandwidth Management
WAN interfaces can be configured with the maximum bandwidth provided by the ISP. When the value (transfer
rate in KBP/S) is configured, the traffic entering the interface is shaped in defined rate.
RV345/345P Administration Guide
49
QoS
WAN Policing