To start the VPN Setup Wizard, click
VPN > VPN Setup Wizard
. Follow the steps below to configure the
Wizard.
Step 1
In the Getting Started section, enter a connection name in the
Give this connection a name
box.
Step 2
Select an interface (
WAN1, WAN2, USB1, or USB2
) from the drop-down list.
Step 3
Click
Next
.
Step 4
In the Remote Router Settings section, select the
Remote Connection Type
from the drop-down list. If you select
IP
Address
, enter the IP Address, or if you select a fully qualified domain name (
FQDN
), enter the name.
Step 5
Click
Next
, to move to the next screen.
Step 6
In the Local and Remote Networks section, under Local Traffic Selection, select the Local IP (
IP Address or Subnet
)
from the drop-down list. If you select
IP Address
, enter the IP address, or if you select
Subnet
, enter the IP address and
subnet mask.
Step 7
Under Remote Traffic Selection, select the Remote IP (
IP Address or Subnet
) from the drop-down list. If you select
IP Address
, enter the IP address or if you select
Subnet
, then enter the IP address and subnet mask.
Step 8
Click
Next
.
Step 9
In the IPSec Profile, select the IPSec profile from the drop-down list.
Step 10
If you select
Default
, then click
Next
.
Step 11
If you select
New Profile
, configure the following:
Phase 1 Options
Select a DH group (
Group 2 or Group 5
) from the drop-down list. DH is a key exchange
protocol, with two groups of different prime key lengths: Group 2 has up to 1,024 bits,
and Group 5 has up to 1,536 bits.
For faster speed and lower security, choose Group 2. For slower speed and higher
security, choose Group 5. Group 2 is selected by default.
Diffie-Hellman (DH) Group
Select an encryption option (
3DES, AES-128, AES-192, or AES-256
) from the
drop-down list. This method determines the algorithm used to encrypt or decrypt
ESP/ISAKMP packets.
Encryption
The authentication method determines how the Encapsulating Security Payload Protocol
(ESP) header packets are validated. The MD5 is a one-way hashing algorithm that
produces a 128-bit digest. The SHA1 is a one-way hashing algorithm that produces a
160-bit digest. The SHA1 is recommended because it is more secure. Make sure that
both ends of the VPN tunnel use the same authentication method. Select an authentication
(
MD5, SHA1 or SHA2-256
).
Authentication
Amount of time an IKE SA is active in this phase. The default value for Phase 1 is
28,800 seconds.
SA Lifetime (Sec)
Check
Enable
to enable PFS and enter the lifetime in seconds, or uncheck
Enable
to
disable.
When the PFS is enabled, the IKE Phase 2 negotiation generates a new key for the IPSec
traffic encryption and authentication. Enabling this feature is recommended.
Perfect Forward Secrecy
(PFS)
RV345/345P Administration Guide
76
VPN
VPN Setup Wizard (Site-to-Site)
Содержание RV340 Series
