Cisco PA-2FEISL-FX, Руководство по установке и настройке

Страница: 16 / 58

1-6
PA-2FEISL 100BASE-T Fast Ethernet/ISL Port Adapter Installation and Configuration
OL-3475-02
Chapter 1 Overview
Cables, Connectors, and Pinouts
Note
Referring to the RJ-45 pinout in Table 1-3 , proper common-mode line terminations should be used for
the unused Category 5, unshielded twisted-pair (UTP) cable pairs 4/5 and 7/8. Common-mode
termination reduces the contributions to electromagnetic interference (EMI) and susceptibility to
common-mode sources. Wire pairs 4/5 and 7/8 are actively terminated in the RJ-45, 100BASE-TX port
circuitry in the PA-2FEISL-TX.
Depending on your RJ-45 interface cabling requirements, use the pinouts in Figure 1-6 and Figure 1-7 .
Figure 1-6 Straight-Through Cable Pinout—PA-2FEISL-TX RJ-45 Connection to a Hub or Repeater
Figure 1-7 Crossover Cable Pinout—PA-2FEISL-TX RJ-45 Connections Between Hubs and Switches
Figure 1-8 shows the duplex SC connector (one required for both transmit and receive), and shows the
simplex SC connector (two required, one for each transmit and receive) used for PA-2FEISL-FX
optical-fiber connections. These multimode optical-fiber cables are commercially available, and are not
available from Cisco.
Figure 1-8 PA-2FEISL-FX Duplex SC Connector
Figure 1-9 PA-2FEISL-FX Simplex SC Connector
Hub or repeater FEIP
5 TxD+
6 TxD–
3 RxD+
4 RxD–
5 RxD+
6 RxD–
3 TxD+
4 TxD–
H3137
Hub or LAN switch
3 TxD+
6 TxD–
1 RxD+
2 RxD–
3 TxD+
6 TxD–
1 RxD+
2 RxD–
H3138
Hub or LAN switch
H2214
H2399