Cisco PA-100VG, Руководство по установке и настройке

Страница: 30 / 38

30 PA-100VG AnyLAN Port Adapter Installation and Configuration
Cisco 7200 Series and 100VG Port Adapters
Figure 19 shows the port adapter slots and interface ports of a Cisco 7206. The port adapter slot
numbers start with 1 and continue through 6 (slot 0 is always reserved for the Fast Ethernet port on
the I/O controller—if present). The individual interface port numbers always begin with 0. The
number of additional ports depends on the number of ports on a port adapter.
For example, the 100VG port on a 100VG port adapter in port adapter slot 3 would have the
address 3/0. (See Figure 19.) If the 100VG port adapter was in port adapter slot 1, this same interface
port would be numbered 1/0.
Figure 19 Cisco 7206 100VG Port Number Example
You can identify interface ports by physically checking the slot/interface port location on the front
of the router or by using
show commands to display information about a specific interface or all
interfaces in the router.
Configuring Interfaces
The following steps describe a basic interface configuration. Press the Return key after each step
unless otherwise noted. At any time you can exit the privileged level and return to the user level by
entering
disable at the prompt as follows:
Router# disable
Router>
Following is an example of a basic configuration procedure:
Step 1
At the privileged-level prompt, enter configuration mode and specify that the console
terminal will be the source of the configuration subcommands as follows:
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#
Step 2
At the prompt, specify the first interface to configure by entering the subcommand
interface , followed by the type ( 100vg ) and slot/port (port adapter slot number and
interface port number). The example that follows is for the first interface of the port
adapter in slot 2:
Router(config)# interface 100vg 2/0
H7902
FAST SERIAL
EN
TD
TC R
D
R
C
LB C
D
TD TC R
D
R
C LB C
D
TD TC R
D
R
C
LB C
D
TD
TC R
D
R
C
LB C
D
EN
A
B
LE
D
M
II
L
IN
K
R
J45
FAST ETHERNET
0
TOKEN RING
0
1 2
3
0
2
4
1
3
5
6
ETHERNET-10BFL
E
N
R
X
0
1
2 3
4
TX R
X TX R
X
TX R
X TX R
X
TX
Cisco 7200
Series
FAST ETHERNET INPUT/OUTPUT CONTROLLER
ENABLED PCMCIA
EJECT SLOT 0
FE
ENABLEFE LINK
CPU RESET 1O POWER
OK
SLOT 1
FE MII
100VG port adapter
(port number 3/0)
ENABLED
100 VG ANYLAN
LINK OK
0
ACTIVITY