16
PA-100VG AnyLAN Port Adapter Installation and Configuration
VIP2 and 100VG Port Adapters
Attaching 100VG Port Adapter Interface Cables
RJ-45 cables are not available from Cisco Systems; they are available from outside commercial cable
vendors.
Use the following procedure to connect RJ-45 cables to the 100VG port adapter:
Step 1
Attach the Category 5 UTP cable directly to the RJ-45 port on the 100VG port adapter.
(See Figure 11.)
Warning
The ports labeled “Ethernet,” “10BASE-T,” “Token Ring,” “Console,” and “AUX” are safety
extra-low voltage (SELV) circuits. SELV circuits should only be connected to other SELV circuits. Because
the BRI circuits are treated like telephone-network voltage, avoid connecting the SELV circuit to the
telephone network voltage (TNV) circuits.
Figure 11
Connecting RJ-45 Cables (Horizontal Orientation—Shown without Handles)
Note
Port adapters have a handle attached, but this handle is not shown to allow a full view of detail
on each port adapter’s faceplate.
Step 2
Attach the network end of your RJ-45 cable to your 100VG hub or repeater or other
external 100VG equipment.
Step 3
Repeat Steps 1 and 2 for each additional 100VG interface.
This completes the 100VG port adapter installation.
H7900
ENABLED
100 VG ANYLAN
LINK OK
0
ACTIVITY
RJ-45 cable
To AnyLAN
network connection
