Cisco CTS 1100, Инструкция по сборке

Страница: 82 / 140

4-2
Cisco TelePresence System 1100 Assembly, First-Time Setup, and Field Replaceable Unit Guide
OL-19695-01
Chapter 4 First-Time Setup
Required Tools and Accessories
Note The procedure differs depending on the type of table that you have in your room; follow the procedure
for your table type.
Step 5
Set up the speakers by completing the procedure in the “Setting Up the Speakers” section on page 4-27 .
Step 6
Set up the microphones by completing the procedure in the “Setting Up the Microphone” section on
page 4-28 .
Step 7 Set up the lights devices by completing the procedure(s) in the “Verifying Proper Function of the Lights”
section on page 4-29 .
Required Tools and Accessories
The following tools are required to set up the CTS 1100 for the first time:
•
3mm round head Allen wrench (for aligning the camera rotation)
•
2.5 mm Allen wrench (used for adjusting the position of the camera)
•
2.5 mm Allen wrench with a minimum 6 inch (15 cm) extension (for adjusting the camera bracket)
• Small spirit level (included with camera kit)
•
Tape for marking areas on the table—Cisco recommends a tape that does not mar the table or leave
a sticky residue, such as masking tape
• Utility knife
•
Tape measure or paper ruler included with the CTS 1100 accessory kit