3-4
Cisco TelePresence System 1100 Assembly, First-Time Setup, and Field Replaceable Unit Guide
OL-19695-01
Chapter 3 Assembling and Mounting a Cisco TelePresence System 1100
Required Tools and Accessories
Required Tools and Accessories
The following tools are required to install the CTS 1100:
•
The following drill bits:
•
1/8-inch (3 mm) drill bit to find stud edges (for steel or wooden studs) or as a pilot hole (for concrete,
concrete block, or brick walls)
•
11/64-inch drill bit (to drill holes in the table for the microphone screws)
•
7/32-inch drill bit (for wooden stud walls)
•
10mm drill bit (for concrete, concrete block, or brick walls)
•
1/2-inch drill bit at least 6 inches (15 cm) long (for drywall anchors in steel stud walls and to drill
holes for the microphone cords)
Note
For more accurate drilling, a drill bit with a pilot tip is recommended.
•
The following sockets:
–
6mm socket (to assemble the bezel)
–
10mm socket (with socket extension)
–
12mm socket with at least a 6-inch (15 cm) socket extension
–
1/2-inch socket (to remove the light reflector)
–
13mm socket (to install the lag screws for wooden stud walls)
•
The following screw drivers:
–
#1 Phillips screw driver with long reach—8 inches (20 cm) minimum
–
#3 Phillips screw driver
–
Flat head screw driver
•
3mm Allen wrench at least 6 inches (15 cm) long (for securing the camera)
•
10mm open end wrench (to remove the light covers)
Note
A 10mm open end ratcheting wrench can be useful to remove the nuts for the light covers.
•
3 mm Allen wrench with a minimum 6 inch (15 cm) extension (for installing the camera bracket)
•
Stud finder
•
Tape measure
•
Pencil or other marking tool (to mark the wall)
•
Duct tape or other tape (to mark the wall and to secure the cables to the underside of the cable cover)
•
Wire cutters for wire cable ties
•
Level
•
Uncrating tools—for example, a pry bar or crow bar
•
Cutting tool (such as tin snips) to remove the metal straps on the crate
