Cisco Content Delivery Engine 100/200/300/400, Руководство по установке оборудования

Страница: 49 / 108

3-9
Cisco Content Delivery Engine 100/200/300/400 Hardware Installation Guide
OL-13478-03
Chapter 3 Installing the Content Delivery Engines
Installing the CDEs
Specifically, the physical connections consist of the following:
ISV System
In a system that uses ISVs that are collocated, the Ethernet cables are used to make the following
physical connections:
• ISV to switch
• CDSM to switch
Specifically, the physical connections consist of the following:
Installing or Removing Disk Drives
The disk drives for the CDEs are shipped separately. You must install the disk drives before using the
CDEs. A minimum of two disks are required for basic software installation (needed for the RAID-1 set).
If the CDE is used to store content (configured as an SE), more than two disks are needed.
For maintenance or other reasons, it may become necessary to remove a disk drive from the chassis. The
disk drives on the CDE100 are monitored using Self-Monitoring, Analysis, and Reporting Technology
(S.M.A.R.T.) and statistics are displayed through the Administrative Interface, as well as sent to the
CDSM. For more information about S.M.A.R.T., see the Cisco Internet Streamer CDS 2.0-2.1 Software
Configuration Guide.
The CDE100 contains 4 disk drives (see Figure 3-6 ), the CDE200 contains 12 disk drives (see
Figure 3-7 ), the CDE300 contains 16 disk drives (see Figure 3-8 ), and the CDE400 contains 24 disk
drives (see Figure 3-9 ).
Figure 3-6 CDE100 Disk Drive Locations
Interface Switch Port Mbps
Vault cache Must be 1000
Vault ingest Can be 100/1000, but 1000 is recommended
Vault management Can be 100/1000
Streamer cache Must be 1000
Streamer stream Must be 1000
Streamer management Can be 100/1000
CDSM management Can be 100/1000
Interface Switch Port Mbps
ISV ingest Can be 100/1000, but 1000 is recommended
ISV management Can be 100/1000
ISV stream Must be 1000
CDSM management Can be 100/1000
2
1
1
859
sda sda sdb sdb sdc sdc sdd sdd