Cisco 7940G, Руководство администратора

Страница: 76 / 184

5-6
Cisco Unified IP Phone 7960G and 7940G Administration Guide for Release 8.0 (SIP)
OL-7890-01
Chapter 5 Monitoring Cisco SIP IP Phones
How to Use the Command-Line Interface to Monitor Phones
SIP Phone> test { open | close | key { k1 ... k12 } |
onhook | offhook | show | hide }
Accesses the remote call test interface, allowing you to
control the phone from a remote site. This command can be
used only if the telnet_level parameter is set to allow
privileged commands to be executed. Keywords are as
follows:
•
open —Enables the use of the test functionality.
•
close —Disables the use of the test functionality.
test command keywords (continued)
•
key —Simulates key presses. The arguments k1 through
k12 are as follows:
– k1—voldn—Volume down
–
k2—volup—Volume up
– k3—headset—Headset
–
k4—spkr—Speaker
– k5—mute—Mute
–
k6—info—Info
– k7—msgs—Messages
–
k8—serv—Services
– k9—dir—Directories
–
k10—set—Settings
– k11—navup—Navigate up
–
k12—navdn—Navigate down
Note You can enter 0 through 9, #, and * in continuous
strings to better express typical dialing strings. A
typical command is
test key 23234 .
•
onhook —Simulates a handset on-hook event.
•
offhook —Simulates a handset off-hook event.
•
show —Shows test feedback.
•
hide —Hides test feedback.
Table 5-1 CLI Commands (continued)
Command Purpose