2-2
Cisco Unified IP Phone 7960G and 7940G Administration Guide for Release 8.0 (SIP)
OL-7890-01
Chapter 2 Installing Cisco Unified IP Phone 7960G and 7940G Hardware on the Desktop or Wall
Cabling the Phone Ports
Figure 2-1
Adjusting the Footstand
Step 3
Modify the handset rest so that the handset remains on the earpiece rest when the phone is vertical.
a.
Remove the handset from the earpiece rest.
b.
Locate the tab (handset wall hook) at the base of the earpiece rest.
c.
Slide this tab out, rotate it 180 degrees, and reinsert it.
d.
Place the handset on the earpiece rest.
Step 4
Insert two screws into a wall stud, matching them to the two screw holes on the back of the footstand.
The screw holes fit standard phone jack mounts.
Step 5
Hang the phone on the wall.
Cabling the Phone Ports
The Cisco IP phone has several ports on the back of the phone, shown in
Figure 1-3 on page 1-5
. Plug
the appropriate equipment into the appropriate port.
Caution
Consider use of an uninterruptible power supply (UPS). Without one, when you use either a local
transformer or inline power on the LAN, the phone is inoperable during a power outage. This affects
your ability to make emergency calls: 911 in USA and Canada, 999 in the UK, and 112 in mainland
Europe.
Note
Use of a headset does not require an amplifier. However, it does require a coil cord to connect the headset
to the headset port. For information on ordering compatible headsets and coil cords, refer to
http://cisco.plantronics.com
or
http://www.vxicorp.com/cisco
.
Cisco IP phone (rear view)
Footstand adjustment
button raises and
lowers adjustment
plate
Adjustment plate
raises and lowers
phone vertically
Adjustment plate
installation
screw holes (2)
62473
Cisco IP phone (rear view)
Footstand adjustment
button raises and
lowers adjustment
plate
Adjustment plate
raises and lowers
phone vertically
Adjustment plate
installation
screw holes (2)
62473
